Why does my Robomow RM400 & Base Station Lawn Mower say 'Close cover'?
If your Robomow Lawn Mower displays 'Close cover', and the bumper cover is not in place, ensure short or slanted obstacles are protected by the perimeter wire. Press the bumper cover downwards until it clicks into place.
How to troubleshoot 'Check power (Base Station)' error on Robomow RM400 & Base Station Lawn Mower?
If your Robomow Lawn Mower displays 'Check power (Base Station)', first confirm that the power supply is properly plugged into the main power receptacle. If that's not the issue, ensure that the main power is turned on and the receptacle is receiving power by testing it with another appliance. Also, clean the mower or Charging Station contacts with a brush or cloth. Finally, check that the power supply is well connected to the Base Station and that the Base Station board cables (green and red) are properly connected to the Base Station contact pins, ensuring the screws are tightened.
How do I fix a 'Check wire' error on my Robomow RM400 & Base Station Lawn Mower?
If your Robomow Lawn Mower displays 'Check wire', inspect and repair any loose, poor, or corroded connections in the perimeter wire. Use only the waterproof connectors supplied in the box for reliable electrical connections. Ensure the perimeter wire does not exceed 500m in length; if it does, divide the area into two separate zones.
What to do if my Robomow RM400 & Base Station Lawn Mower shows a 'Low battery' message?
If your Robomow Lawn Mower displays 'Low battery', manually drive the mower using the remote control or carry it to the Base Station for charging. To prevent this in the future, ensure there is at least 16 hours between scheduled operations to allow sufficient charging time.
Why does my Robomow RM400 & Base Station Lawn Mower get stuck in place?
If your Robomow Lawn Mower is stuck in place, check the ground for any holes or indentations where the mower might have stopped, especially near the perimeter wire, and fill them with dirt to level the surface. Also, make sure the area is not too sloppy and work in dry conditions. Check that the perimeter wire is not too close to the edge, and adjust if necessary. Ensure the mowing deck is not set too low.
What to do if my Robomow RM400 & Base Station Lawn Mower displays 'Recharge battery'?
Connect the charger to the mower.
What to do if my Robomow RM400 & Base Station Lawn Mower displays 'Frnt wheel prob'?
If your Robomow Lawn Mower displays 'Frnt wheel prob', remove the battery fuse before lifting the mower. Remove any obstacles or exclude them from the mowing area. Exclude steep slopes from the mowing area. Raise the cutting height if high grass is the issue. Fill any large holes or indentations in the ground.
How do I fix 'Splice wire' error on my Robomow Lawn Mower?
Confirm wire is plugged in and wire leads are firmly attached. Walk along the perimeter, including islands, and look for obvious cuts or breaks in the wire. Repair with Robomow wire splice connectors.
What to do if my Robomow RM400 & Base Station Lawn Mower says 'Peg base then press GO'?
If your Robomow Lawn Mower displays 'Peg base then press GO', fasten the base in place using the two stakes.
What to do if my Robomow RM400 & Base Station Lawn Mower says 'Wire outside'?
If your Robomow Lawn Mower displays 'Wire outside', move the wire towards the inner side of the lawn, avoiding areas with steep slopes. Fill any holes or pits in the ground and increase the cutting height.
General| Brand | Robomow |
|---|---|
| Model | RM400 & Base Station |
| Category | Lawn Mower |
| Language | English |
To Next Page
