Robomow RM400 & Base Station - Robomow Preparation and Settings

Flashing light
indicates the s
y
stem
Figure 1.24 -
Base Station
Operating Panel
Continuous beeps indicate a
disconnected
/
broken wire
Discontinuous beeps indicate
poor splicing of perimeter wires
or
p
erimeter wire
,
which is too
1.5 Robomow Preparation and Settings
1.5.1 Setting The Cutting Height
 Lift the Bumper Cover from the front side of the Robomow (figure 1.25).
 To change the cutting height, rotate the cutting height adjustment knob, as shown in figure 1.26.
Figure 1.25 -
Lifting the Bumper Cover
Figure 1.26 -
RM400 General View
Mowing
motor
Cutting height
adjustment
knob
Carrying
handle
Winter Charge
r
location
Fuse locationControl Panel
21