What to do if my Robomow Lawn Mower shows a 'Failure: xyz' message?
If your Robomow Lawn Mower displays 'Failure: xyz', press ‘go’ to confirm the message. If the message persists, remove the battery fuse for 10 seconds and retry. If the message continues, contact your service dealer.
How to troubleshoot 'Check power (Winter charger)' error on Robomow RM400 & Base Station Lawn Mower?
If your Robomow Lawn Mower displays 'Check power (Winter charger)', confirm the power supply is plugged into the main power receptacle. If that's not the issue, ensure that the main power is turned on and the receptacle is receiving power by testing it with another appliance.
How to fix a 'Base problem' error on my Robomow Lawn Mower?
If your Robomow Lawn Mower displays 'Base problem', adjust the Base Station position, clean the contacts with a brush or cloth, ensure good cable connections, and confirm the Base Station is level with the ground.
What to do if my Robomow Lawn Mower says 'No wire signal'?
If the Robomow Lawn Mower displays 'No wire signal', ensure the Base Station is connected to the mains supply. Disconnect and reconnect the Base Station power supply after 10 seconds. Check the Perimeter Switch is connected to the correct zone and turned on. Also, verify the connection of the perimeter wire to the Base Station/Perimeter Switch and inspect the perimeter wire for any cuts.
What to do if my Robomow RM400 & Base Station Lawn Mower displays 'Remove fuse then check blade'?
If your Robomow Lawn Mower displays 'Remove fuse then check blade', remove the battery fuse before lifting the mower. Inspect the blades for any foreign material or debris preventing rotation and clean out accumulated grass clippings using a wooden stick.
What to do if my Robomow RM400 & Base Station Lawn Mower says 'Peg base then press GO'?
If your Robomow Lawn Mower displays 'Peg base then press GO', fasten the base in place using the two stakes.
What to do if my Robomow RM400 & Base Station Lawn Mower says 'Insert fuse for charging'?
If your Robomow Lawn Mower displays 'Insert fuse for charging', disconnect Robomow from charging, insert the battery fuse, and then reconnect it to charging.
What to do if my Robomow RM400 & Base Station Lawn Mower says 'Wire outside'?
If your Robomow Lawn Mower displays 'Wire outside', move the wire towards the inner side of the lawn, avoiding areas with steep slopes. Fill any holes or pits in the ground and increase the cutting height.
What to do if Robomow RM400 & Base Station Lawn Mower displays 'Change wires in plot connector'?
If your Robomow Lawn Mower displays 'Change wires in plot connector', switch the two wire ends connected to the plot connector (the green connector connected to the Base Station). This message appears if the perimeter wire is connected with the wrong polarity after setup.
What should I do if my Robomow RM400 & Base Station Lawn Mower says 'Bumper pressed'?
If your Robomow Lawn Mower displays 'Bumper pressed', move the mower away from the object that is pressing against the bumper.
General| Brand | Robomow |
|---|---|
| Model | RM400 & Base Station |
| Category | Lawn Mower |
| Language | English |
To Next Page
