14
D2
Side Brush
*
Clean monthly and replace every 3-6 months.
Unscrew the side brush screw. Remove and
clean the side brush. Then, align the central
groove with the raised position on the robot
and tighten the screw to reinstall the side brush.
Clean the main wheels with a soft, dry cloth.
D4
Main Wheels
*
Clean as required.
D3
Omnidirectional Wheel
*
Clean as required.
The omnidirectional wheel bracket cannot be
removed.
Note:
D3-1—Use a tool, such as a small
screwdriver, to pry out the axle and
take out the wheel.
D3-2—Rinse the wheel and the axle with
water to remove any hair and dirt.
Air-dry, reinstall, and press the wheel
and axle back in place.
D5
Dustbin
*
Clean as required.
D5-1—Remove the magnetic top cover of
the robot and pinch the dustbin
latch to take out the dustbin.
D5-2—Pinch the dustbin lid latch to open it
and remove the washable filter, then
empty the dustbin.
D5-3—Fill the dustbin with clean water,
reinstall the washable filter and
close the dustbin lid. Gently shake
the dustbin, and then pour out the
dirty water.
To prevent blockage, only use clean water without
any cleaning liquid.
Note:
D5-4—Allow at least 24 hours for the dustbin
and washable filter to dry thoroughly
before reinstalling them.
D6
Washable Filter
*
Clean every 2 weeks and replace every 6-12 months.
Do not touch the surface of the filter with hands,
brushes, or hard objects to avoid potential damage.
Note:
D6-1—Pinch the dustbin lid latch to open it
and remove the washable filter.
D6-2—Rinse the filter repeatedly and tap it
to remove as much dirt as possible.
D6-3—Allow at least 24 hours for the filter to
dry thoroughly before reinstalling it.
D8
VibraRise Mop Cloth
*
Clean as required and replace every 3-6 months.
A dirty mop cloth will affect the mopping
performance. Clean it before use.
Note:
D8-1—Remove the mop cloth from the mop
cloth mount. Clean the mop cloth
and air-dry it.
D8-2—Slide the mop cloth in from the
opening of the attachment slot, and
then stick it flat in place.
D9
Robot Sensors
Use a soft, dry cloth to wipe and clean all
sensors, including:
D9-1—Upward Sensor
D9-2—Dock Locator
D9-3—Reactive AI Obstacle Recognition
Sensor
D9-4—Wall Sensor
D9-5—Communication Sensor
D9-6—Cliff Sensors
D9-7—Carpet Sensor
*
Clean as required.
D10
Charging Contacts
Use a soft, dry cloth to wipe the charging
contacts on the robot and the dock.
*
Clean as required.
D11
Moving the Dock
To move the dock, grip the power cord
storage slot on the back with one hand and
the inner side of the front board with the
D7
Edgewise Mop Cloth
*
Clean as required and replace every 3-6 months.
D7-1—Unscrew the screw in the middle of
the mop cloth. Wash the mop cloth
and air-dry it.
D7-2—Reinstall the mop cloth and tighten
the screw.
A dirty mop cloth will affect the mopping
performance. Clean it before use.
Note:
Notes:
• It is recommended to wipe the main brushes with a
wet cloth. If the main brushes are wet, air-dry them
away from direct sunlight.
• Do not use corrosive cleaning fluid or disinfectant to
clean the main brushes.
To Next Page
Loading...
