15
D13
High-Speed Maintenance
Brush
Lift the high-speed maintenance brush
latch and remove the brush. Remove
any entangled objects in the high-speed
maintenance brush and rinse it clean.
Reinstall the brush and latch it in place.
*
Clean as required and replace every 6-12 months.
D14
Water Filter
Pull out the water filter by its latch. Rinse it
with water, use a soft, dry cloth to wipe the
cleaning sink, and then reinstall the filter.
Press down the filter until you hear it lock
with a click.
*
Clean as required.
D12
Dirty Water Tank
Open the dirty water tank lid and pour
out the dirty water. Fill the tank with clean
water, close the lid, lock the latch, and
shake. Pour out the dirty water. Lock the lid
and reinstall the tank.
*
Clean as required.
Notes:
• To avoid deformation, only use cold water.
• If any water stains remain on the outside of the
water tank, wipe them with a soft, dry cloth before
reinstalling the tank.
To prevent damage, do not pull the door open.Note:
Notes:
• The dust bag handle seals the bag on removal to
prevent leakage.
• Always install a dust bag before closing the dust
container door to avoid auto-emptying without the
bag. You can also disable auto-emptying in the app.
D16
Replacing Disposable Dust Bag
*
Replace as required.
D16-1— Press the dust container door to
open it.
D16-2— Remove the disposable dust bag
and discard it.
D16-3—
Clean the filter with a dry cloth,
insert a new disposable dust bag
into the slot all the way in, and
spread it evenly.
Make sure the disposable dust bag is properly
installed to avoid waste escaping and damaging the dock.
Note:
D16-4—Close the dust container door to
make sure the dust container is
securely sealed.
D15
Cleaning Tray of Edgewise
Mopping Module
*
Clean as required.
D15-1— Remove the cleaning tray.
D15-2— Rinse the cleaning tray with water.
D15-3— Reinstall the cleaning tray.
other hand. Do not lift the dock base, dock
cover, or dust container door directly to
prevent the dock from falling off.
To Next Page
Loading...
