13
After mop washing or after cleaning, drying
will begin as needed. To manually start or
stop drying, tap the corresponding button
in the app.
Drying
• Stay away from the drying air outlets during drying.
• Drying duration can be modified in the app.
• Auto-drying can be disabled in the app.
Notes:
Charging
After cleaning, the robot will automatically
return to the dock to charge. Press
to
send the paused robot back to the dock.
The power indicator light will breathe
during robot charging.
If the robot fails to find the dock, it will
automatically return to its starting position. Place the
robot on the dock manually to recharge.
Note:
• The robot will go to sleep automatically if left in a
malfunctioning state for over 10 minutes.
• Placing a malfunctioning robot on the dock manually
will end the current cleanup.
Notes:
Error
If an error occurs, the power indicator light
will flash red or status indicator light will be
steady red. A pop-up notification will appear
in the app and a voice alert may sound.
Resetting the System
If the robot does not respond when a
button is pressed or cannot be turned off,
reset the system by removing the magnetic
top cover and pressing the Reset button.
After resetting the system, existing settings such
as scheduled cleaning and WiFi will be restored to
factory settings.
Note:
Restoring Factory Settings
If the robot does not function properly after
a system reset, power it on. Press and hold
and at the same time, press the Reset
button until you hear the “Restoring factory
settings. This will take about 5 minutes.” voice
message. The robot will then be restored to
factory settings.
Routine Maintenance
D
*
Clean every 2 weeks and replace every 6-12 months.
D1-1—Main Brush Cover
D1-2—Main Brush Cover Latches
D1-3—Main Brushes
D1-4—Main Brush Bearings
D1
Main Brushes
• The product must be switched off and the plug must
be removed from socket outlet before cleaning or
maintaining the product.
• The frequency of replacement may vary with the
actual situation. If abnormal wear occurs, replace the
parts immediately.
Notes:
D1-5—Turn over the robot and press the
two latches inwards to remove the
main brush cover.
D1-6—Lift the main brushes, pull them out,
and remove main brush bearings.
Remove any entangled hair or dirt at
both ends of the main brushes and
bearings.
D1-7—Reinstall the main brush bearings. And
then, reinstall the main brushes and
make sure the color of the main brush,
main brush bearing and the arrow on
the robot match.
D1-8
—
Reinstall the main brush cover. Make
sure its four teeth are fully seated in
the slots, and press the main brush
cover until you hear it lock with a click.
DND Mode
The default Do Not Disturb (DND) period is
from 22:00 to 08:00. You can use the app to
disable the DND mode or modify the DND
period, or set whether to enable auto top-up,
emptying and drying, to dim indicator
lights, or lower the volume of the voice
message during the DND period.
Child Lock
Press and hold to enable/disable Child
Lock. You can also set it in the app. Once
enabled, the robot will not react to button
presses when it is stationary. When the
robot is cleaning or docking, tap any button
to pause it. When it is doing so under
furniture or appliances, tap
and then
double tap
to pause it.
To Next Page
Loading...
