Roborock Saros 10 - Environmental Protection Information; Removing the Battery; Basic Parameters

16
Removing the battery
The chemical substances contained in the
built-in lithium-ion battery of this product
can cause environmental pollution. Remove
the battery before disposing of this product
and hand it to a professional battery
recycling facility for centralized disposal.
1. Operate the robot without connecting to
the dock until it runs out of battery.
2. Turn off the robot.
3. Unscrew the battery cover.
4. Remove the battery cover.
5. Press the latch to pull out the battery
connector and remove the battery.
Notes:
• Before removing the battery, make sure it is fully
drained and the robot is disconnected from the dock.
• Remove the entire battery pack. Avoid damaging the
battery pack casing to avoid short-circuits or leakage
of hazardous substances.
• In the event of accidental contact with battery fluid,
rinse thoroughly with water and seek immediate
medical care.
Environmental
Protection Information
How to remove the battery:
*
The following information applies only when disposing
of the robot and should not be followed for day-to-day
operations.
Basic Parameters
Model S90VER
Battery
14.4 V/6400 mAh (TYP)
lithium-ion battery
Rated Input
20 V
2.5 A
Robot
The serial number is on a sticker on the underside
of the robot.
Note:
Empty Wash Fill Dock
Model EWFD32LRR
Rated Input
Voltage
120 V~
Rated Frequency 60 Hz
Rated Input (Dust
collection)
6 A
Rated Input
(Hot-water mop
washing)
12 A
Rated Input
(Charging & drying)
1.5 A
Rated Output
20 V
2.5 A