operating time under different temperature range respectively.
Note：
1. The diagnostic screen is refreshed every second.
2. If the voltage/current box turns red, please check whether the LiDAR is currently in Standby mode, if not, check
whether the LiDAR is working normally;
3. The number of start-up times is refreshed after 1 minute after the LiDAR is circle powered again, and the
operating time is refreshed every 1 minute.
A.4 System Screen
Click the System button on the front page of the Web Interface, you will see the System Screen,
where you can update the top board firmware, bottom board firmware, software, web and motor
firmware. The procedure of firmware update, taking the Top Board Firmware Update as an example,
is as shown below:
1. Prepare the Top Board firmware that is going to be used for the update. Click the Choose File
button to navigate to the folder where the new TOP Board firmware is located.
Figure A-4 Click Choose File to Find the New Firmware
2. Select the right firmware that is going to be used for the update, and click Open to upload
the file. (The saving path of the firmware should only contain English characters)
To Next Page
Loading...
