Warnings
6
III
This Installation, use and maintenance manual
must always accompany the appliance and must
be handed to the new owner or installer in the
event of sale or removal.
III.2 CONFORMITY
EU directives and standards
The M series gas unit heaters meet the essential require-
ments of the following Directives:
▶
2014/30/EC "Electromagnetic Compatibility Directive"
as amended and added.
▶
2014/35/EC "Low Voltage Directive" as amended and
added.
▶
2006/42/EC "Machine Directive" as amended and add-
ed.
Furthermore, they comply with the requirements of the
following standards:
▶
EN 1020 Non-domestic forced convection gas-red air
heaters for space heating not exceeding a net heat in-
put of 300 kW incorporating a fan to assist transporta-
tion of combustion air or combustion products.
▶
prEN 17082 Domestic and non-domestic gas-red
forced convection air heaters for space heating not ex-
ceeding a net heat input of 300 kW.
Other applicable provisions and standards
The design, installation, operation and maintenance of
the systems shall be carried out in compliance with cur-
rent applicable regulations, depending on the Country
and location, and in accordance with the manufacturer's
instructions. In particular, regulations regarding the fol-
lowing shall be complied with:
▶
Gas systems and equipment.
▶
Electrical systems and equipment.
▶
Heating systems.
▶
Environmental protection and combustion products
exhaust.
▶
Fire safety and prevention.
▶
Any other applicable law, standard and regulation.
III.3 EXCLUSIONS OF LIABILITY AND
WARRANTY
Any contractual or extra-contractual liability of the
manufacturer for any damage caused by incorrect
installation and/or improper use and/or failure to
comply with regulations and with the manufactur-
er's directions/instructions shall be disclaimed.
In particular, the warranty on the appliance may be
rendered void by the following conditions:
Incorrect installation.
Misuse.
Failure to comply with the manufacturer's indica-
tions on installation, use and maintenance.
Alteration or modication of the product or any
part thereof.
Extreme operational conditions or however out-
side of the operational ranges set forth by the man-
ufacturer.
Damages caused by external agents such as salts,
chlorine, sulphur or other chemical substances
present in the air of the installation site.
Abnormal actions transmitted to the appliance by
the system or installation (mechanical stresses,
pressure, vibrations, thermal expansion, electrical
surges...).
Accidental damages or due to force majeure.
To Next Page
Loading...
