Installation, use and maintenance manual – Supercromo
3
INDEX OF CONTENTS
I Introduction ..........................................................................
p.4
I.1 Recipients ................................................................
p.4
II Symbols and denitions .........................................
p.4
II.1 Key to symbols ......................................................
p.4
II.2 Terms and denitions .........................................
p.4
III Warnings ...................................................................................
p.4
III.1 General and safety warnings ............................
p.4
III.2 Compliance .............................................................
p.5
III.3 Exclusions of liability and warranty ...............
p.6
1 Features and technical data ................................
p.7
1.1 Features ....................................................................
p.7
1.2 Dimensions .............................................................
p.8
1.3 Electrical wiring diagram ...................................
p.8
1.4 Controls ....................................................................
p.9
1.5 Technical data ........................................................
p.9
2 Transport and positioning ....................................
p.9
2.1 Warnings ..................................................................
p.9
2.2 Handling ..................................................................
p.9
2.3 Appliance positioning ......................................
p.10
2.4 Minimum clearance distances .......................
p.10
3 Heating engineer...........................................................
p.10
3.1 Warnings ................................................................
p.10
3.2 Supplied material ...............................................
p.10
3.3 Fuel gas supply ....................................................
p.10
3.4 Combustion products exhaust ......................
p.12
3.5 Installation procedure ......................................
p.14
4 Electrical installer .........................................................
p.16
4.1 Warnings ................................................................
p.16
4.2 Electrical power supply ....................................
p.16
5 First start-up .......................................................................
p.17
5.1 Preliminary checks .............................................
p.17
5.2 Checking burner gas pressure .......................
p.17
5.3 Gas changeover ..................................................
p.18
6 Normal operation .........................................................
p.19
6.1 Warnings ................................................................
p.19
6.2 Control panel .......................................................
p.20
6.3 Switch on and o ................................................
p.20
6.4 Programmable timer .........................................
p.20
7 Maintenance .......................................................................
p.23
7.1 Warnings ................................................................
p.23
7.2 Cleaning and maintenance .............................
p.23
7.3 Safety devices ......................................................
p.23
7.4 Any malfunctions of operation .....................
p.23
8 Appendices ...........................................................................
p.25
8.1 ErP data sheets ....................................................
p.25