Robur Supercromo - User Manual

Installation, use and maintenance manual
Supercromo
Fired by natural gas/LPG
Independent gas-red convectors with direct exchange
to heat small and medium sized rooms

Summary

WARNINGS

III.1 General and Safety Warnings

Provides essential general safety instructions and warnings for installation and use.

In the Event of Failure

EXCLUSIONS OF LIABILITY AND WARRANTY

FEATURES AND TECHNICAL DATA

TRANSPORT AND POSITIONING

2.1 Warnings

2.3 Appliance Positioning

Specifies recommended locations and restrictions for installing the appliance.

2.4 Minimum Clearance Distances

Defines the required clearance distances for safety, operation, and maintenance.

HEATING ENGINEER

3.3 Fuel Gas Supply

Details requirements and procedures for connecting the gas supply.

3.3.1 Gas Connection

Instructions for physically connecting the gas supply pipe to the appliance.

3.3.2 Mandatory Shut-off Valve

3.3.4 Supply Gas Pressure

Defines the acceptable gas supply pressure range for the appliance.

3.4 Combustion Products Exhaust

Details requirements for connecting the appliance to the exhaust system.

3.4.1 Flue Gas Exhaust and Combustion Air Intake Connection

Specifies the connection points for flue gas exhaust and air intake.

INSTALLATION PROCEDURE

3.5.1 Install the Gas-Fired Convector on the Wall

Step-by-step guide for mounting the gas-fired convector onto the wall.

ELECTRICAL INSTALLER

4.1 Warnings

4.2 Electrical Power Supply

Details the requirements and procedures for connecting the appliance's electrical power supply.

How to Connect the Power Supply

Detailed instructions for connecting the appliance's electrical power supply.

FIRST START-UP

5.1 Preliminary Checks

Essential checks to perform before contacting the TAC for the first start-up.

5.2 Checking Burner Gas Pressure

Procedure for checking and adjusting gas pressure for natural gas operation.

5.2.1 Natural Gas Supply

Procedure for checking and adjusting gas pressure for natural gas operation.

5.2.2 LPG Supply

Instructions for adjusting the convector for LPG operation, including pressure checks.

5.3 Gas Changeover

Details the process and requirements for changing the appliance's gas type.

5.3.1 Conversion from Natural Gas to LPG

NORMAL OPERATION

6.1 Warnings

6.3 Switch On and Off

6.3.1 Switching On

6.3.2 Switching Off

6.4 Programmable Timer

6.4.1 Features

6.4.2 Programmable Timer Installation

6.4.3 Timer Programming

6.4.3.1 Setting the Date and the Time

6.4.3.2 Set the On;Off Programs

MAINTENANCE

7.1 Warnings

7.2 Cleaning and Maintenance

7.3 Safety Devices

7.4 Any Malfunctions of Operation

Guidance on checking common issues before troubleshooting specific malfunctions.

7.4.1 Case 1: The Appliance Locks Out During the First Start-Up Phase

Troubleshooting steps for lock-out issues occurring during initial appliance start-up.

7.4.2 Case 2: The Appliance Locks Out During Normal Operation

Troubleshooting steps for lock-out issues occurring during normal appliance operation.

Robur Supercromo Specifications

General

Frequency	50 Hz
Adjustable Thermostat	Yes
Remote Control	No
Timer	No
Voltage	220-240V