9
10 Clean and Maintenance
IR filter cleaning
Please keep IR filter clean, you may apply with neutral detergent and soft cloth for cleaning.
Cleanser, abrasive grinding powder, oil or acid or alkaline detergent are forbidden to apply to clean this product. Do not directly
spray air fresheners, disinfection liquid or other deodorizer, cleaning organic solvents to IR filter. Water resource used for this product
should be domestic water or applicant water in order to preventing to use acid, alkaline processed water or dirty water containing
more impurities.
OFF
ON
Adjust the water flow rate
1. Use a stainless needle (not provided) to insert into IR filter, disassemble screws , panel and bracket by using screw driver.
2. Apply with screw driver to adjust flow rate knob to its appropriate demand.
Clean the filter
The sensor valve is equipped with filter device, but if there are impurities in the pipe or the water quality is bad, the flushing result will
become bad after long term usage, then it is time to clean the filter.
1. Use a stainless needle to insert into IR filter , disassemble screws , panel and bracket by using screw driver.
2. Apply with screw to turn the flow rate knob for stopping water supply.
3. Open filter cover and take out filter net for cleaning.
4. After finishing the cleaning steps, have filter net to be re-installed, turn on flow rate knob. Please be aware if the packing is
missed during filter cover installation.
NOTE :
It is recommended only disassemble two screws at one time while disassembling fixing bracket.
Please avoid taking out four screws at the same time, this will cause difficult installation.
Adjust the water flow rate
Filter
Clean the filter Filter net to be re-installed
Take out filter net
To Next Page
Loading...
