25
Connecting to a PC
6
Connecting the Meter to a PC
Using a USB Cable
Follow the steps below to access
diabetes management software on a PC.
You can use this software to view stored
results, set the meter time and date, and
change the target range.
Plug the small end of
a USB cable into the
meter.
Plug the large end of
a USB cable into a
USB port on the PC.
If the meter is o, it
turns on.
Start the diabetes management
software and initiate a data transfer.
The meter transfers
the data to the
software.
NOTE
The USB cable does not charge the
meter batteries. Remove the USB
cable after you have finished.
83715_09767959061A.indd 2583715_09767959061A.indd 25 6/29/2021 11:30:55 AM6/29/2021 11:30:55 AM
To Next Page
Loading...
