EasyManuals Logo

Roche Accu-Chek Performa Nano User Manual

Roche Accu-Chek Performa Nano
92 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #30 background imageLoading...
Page #30 background image
Control Tests
28
4
Touch the drop to the
front edge of the yellow
window of the test strip
until you see flash.
Do not put control
solution on top of the
test strip.
5
Remove the cap from the
control solution bottle.
Wipe the tip of the bottle
with a tissue.
Squeeze the bottle until
a tiny drop forms at the
tip.
4
Insert the test strip into
the meter in the direction
of the arrows.
Place the meter on a flat
surface.
Check the useby date
on the test strip
container. Do not use
test strips past the
useby date.
1
Performing a Control Test
You need the meter with pre‑inserted activation chip, a test strip, and control solution Level1, Level2, or
both. The control level is printed on the bottle label.
Select the control
solution to test. You will
enter the level later in
the test.
32
or
6
When you see flash,
there is enough control
solution in the test strip.
Wipe the tip of the bottle
with a tissue. Cap the
bottle tightly.
79718_07255233050_01_EN.indb 28 5/22/2019 1:44:54 PM

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Roche Accu-Chek Performa Nano and is the answer not in the manual?

Roche Accu-Chek Performa Nano Specifications

General IconGeneral
BrandRoche
ModelAccu-Chek Performa Nano
CategoryBlood Glucose Meter
LanguageEnglish

Related product manuals