Roche/Hitachi cobas c 311 analyzer Record structure
Message Header Record
Roche Diagnostics May 2011
Host Interface Manual – Version 1.3 E-7
Message Header Record
cobas type (Upload, Download)
H|\^&|||cobas c 311^1|||||host|RSUPL^BATCH|P|1[CR]
(1) (2) (3) (4) (5) (6) (7)
Comments No
Field
No.
Field Type Max
cobas Type
(1) 1 Record Type ID ST 1 ‘H’ fixed.
(2) 2 Delimiter Definition ST 4 Four characters such as field separator character, repeat separator character, component
separator character, and escape character are defined. The first character is defines as a
field separator character and Record Type ID separator as well. These four characters are
‘|\^&.’
3 Message Control ID
Field does not contain data
4 Access Password
Field does not contain data
(3) 5 Sender Name or ID CM 36 .
Setting is as follows:
<Sender’s device name>^<Communication program version>
<Sender’s device name> Type:TX Max: 30
Any characters within alphanumeric and ‘-.‘
<Communication program version> Type: NM Max: 5
‘1’ fixed.
6 Sender Street Address
Field does not contain data
7 Reserved Field
Field does not contain data
8 Sender Telephone Number
Field does not contain data
9 Characteristics of Sender
Field does not contain data
(4) 10 Receiver ID ST 30 Receiver’s name.
Sending from cobas c 311 analyzer.
Sending from HOST: any characters within alphanumeric and ‘-.‘
(5) 11 Comment or Special
Instructions
CM 11 Setting is as follows:
<Meaning of message>^< Mode of message >
<Meaning of message> Type: ST Max: 5
‘TSREQ’: TS inquiry.
‘TSDWN’: Test selection download.
‘RSUPL‘: Result report
‘PCUPL‘: Photometry calibration report
‘ICUPL‘: ISE calibration report
‘ABUPL’: Absorbance report
‘RSREQ’: Inquiry for the result
<Mode of message> Type: ST Max: 5
‘REAL’: communication in real time.
‘BATCH’: communication based on request from cobas c 311/HOST.
‘REPLY’: reply to the request.
(6) 12 Processing ID ST 1 ‘P’ fixed.
(7) 13 Version No. NM 1 ‘1’ fixed.
14 Date and Time of Message
Field does not contain data
To Next Page
Loading...
