The transmitter and model setup
page15
Get your model ready to fly
Before getting started, bind your receiver with your transmitter. Please refer to your
Transmitter Manual for proper operation.
CAUTION: To prevent personal injury, DO NOT install the propeller assembly onto the
motor shaft while testing the control surfaces . DO NOT arm the ESC and do not turn on
the transmitter until the Transmitter Manual instructs you to do so.
Tips: Make sure all control sticks on your radio are in the neutral position (rudder,
elevator, ailerons) and the throttle in the OFF position. Make sure both ailerons
move up and down (travel) the same amount. This model tracks well when the
left and right ailerons travel the same amount in response to the control stick.
1. Move the controls on the transmitter to make sure aircraft control surface move
correctly. See diagrams below.
Aileron
Elevator
Left
steering
Right
steering
Steering
Bank Left
Bank Right
Climb
Descend
Steer Left
Steer Right
For More Info Vist: www.motionrc.com
To Next Page