INSTALLATION
This espresso machine is to be installed with adequate backflow protection to comply with
applicable federal, state, and local codes.
All machines are designed to ensure maximum possible user safety. It is, however, an important responsibility
of the user to observe the following safety codes to further enhance safe installation and operation.
1.
Always ensure that hazardous packing items such as plastic bags, Styrofoam, nails, etc. are properly
disposed of to prevent accidental injury to children or other persons.
2.
If there is evidence of defect or damage to the machine an authorised Rocket Espresso Ltd. dealer or
technician should be notified immediately so that remedial action can be taken.
3.
This machine is safe only when it has been correctly connected to an efficient earthing/grounding
system. This should conform to local safety standards and legislation in force at the time of installation.
4.
Installation of any Rocket Espresso Ltd. product should only be undertaken by duly authorised, properly
trained and qualified personnel
5.
Protect the user by fitting a circuit breaker to electric supply feeding the machine.
6.
A residual current device (RCD) having a rated residual operating current not exceeding 30mA must be
installed.
7.
The machines with electrical input over 16 A, must be connected to a net with impedance = or < than
0,37 Ω.
8.
Dangerous or improper electrical connections are extremely hazardous and should never occur.
9.
Always check the integrity of the component content of the machine. Never fit defective or damaged
spare parts. Always request replacement spare parts from Rocket Espresso Ltd.
10.
Before connecting the machine to electric supply, always check that capacity and power rating at least
equals the power requirement of the machine.
11.
The machine has to operate with clean soft drinking water. Never attempt to run the machine with
water that is harder than 7°F. The manufacturer recommends use of an in line filter.
12.
Check the efficiency of the machine’s water drain. Drain tray is located under the drip tray
13.
This equipment must be installed on a flat, level and stable surface. The minimum height of this surface
is 1025 mm
14.
Handle the machine with care.
To Next Page
Loading...
Need help?
General
