17
R9V
4 - INSTALLATION
The Coè machine is only to be installed
in locations where use and maintenance is
restricted to trained personnel.
The support surface shall be leveled, dry,
smooth, steady and stable and at such a
height that the cup-warming surface is at over
150 cm from ground. (g._4.1)
Do not use or install where water jets are used.
g_4.2
g_4.1
In order to guarantee normal operation, the
machine must be installed in areas where the
environmental temperature is between +6°C
and +36°C; and the humidity is not over 70%.
Please make sure that there is an open area
of at least 10 cm on each side and behind the
machine to allow adequate ventilation and
facilitate its use and the performance of any
maintenance operations. (g._4.2)
If the machine is wet or very
damp, wait until it is completely
dry before installing or using it. It
is always necessary to request
an accurate control to qualied
service people in order to nd
any possible damage to the elec-
tric components.
A grounds drawer should be tted by the
installer.
To Next Page
Loading...
