Rocket Espresso R9V - Page 34

34
R9V
HOT WATER NOZZLE
1. Clean the hot water spout, check that the
nozzle is not encrusted. Unscrew the noz-
zle and if it become encrusted, clean it be
(prepare a solution of detergent according
to the instructions) careful not to deform or
damage them. (g._7.2).
BACKFLUSHING
1. Remove the lter basket from the portalter
and t the back ush cap.
2. While the brew water is owing loosely
insert the portalter into the group head,
rotating the portalter back and forth. Keep
emptying the blind basket of hot water and
old grounds until the water runs clear.
3. You should backush the group head every
day.
GROUP BREW HEAD
1. Every week, after backushing, add a small
amount of espresso cleaning detergent to
the blind basket. Dissolve the detergent in
hot water and insert the portalter into the
group head. Use a solution readily available
at your local store.
2. Turn the group paddle on and o󰀨 again
after about 10 seconds. Repeat this several
times.
g_7.2
3. Empty the basket of the detergent and
backush using water only as above until
the group is thoroughly cleansed of deter-
gent residue.
REMOVING THE SHOWER FOIL AND HEAD
SEAL
1. Using a number 3 allen key remove the
shower foil and dispersion screen (g._7.3).
g_7.3
2. Scrub the inside of the group head with the
supplied group cleaning brush. (g._7.4)
g_7.4