To Next PageTo Next Page
Need help?Do you have a question about the Rockwell Automation 2080-L50E-24QWB and is the answer not in the manual?
General| Brand | Rockwell Automation |
|---|---|
| Model | 2080-L50E-24QWB |
| Category | Controller |
| Language | English |
Overview of Micro830, Micro850, and Micro870 controller hardware features.
Details on Micro830 controllers, including 10/16-point and 24-point variants.
Details on Micro850 controllers, including 24-point and 48-point variants.
Details on Micro870 controllers, including 24-point variants.
Overview of Connected Components Workbench software for Micro800 controllers.
How to make changes to a running controller using RMC and RMCC.
Explains RMC for logic modifications in a running project without going to program mode.
Allows changing address configurations of controllers in run mode using RMCC.
Important safety considerations for system installation.
Guidance on locating and using the main power disconnect switch.
General guidelines for wiring controllers, including conduit and labeling.
Guidelines for grounding the controller, referencing Industrial Automation Wiring and Grounding Guidelines.
Illustrations showing wiring diagrams for Micro800 controllers with DC inputs wired as sinking or sourcing.
Lists communication protocols supported by Micro830/850/870 controllers and Micro850/870 controllers only.
Details configuring DNP3 communication for serial and Ethernet ports.
Provides an overview of running and executing programs with a Micro800 controller.
Details EtherNet/IP network functionality, topologies, and communication rates.
Explains PTO/PWM and motion axis support on Micro830, Micro850, and Micro870 controllers.
Overview of components of motion control and necessary steps to use the feature.
Instructions that configure or act upon an axis of motion.
Overview of HSC components, hardware, and instructions for Micro800 controllers.
Explains HSC's use for detecting fast pulses and initiating control operations based on presets.
Details HSC capabilities like 100 kHz operation, direct output control, and programmable presets.
Explains the HSC function block for starting, stopping, refreshing, reloading, and resetting HSC.
Configures HSC to operate as PLS or rotary cam switch using PLS data block.
Restricts operations that can disrupt controller operation based on operating mode.
Prevents simultaneous configuration by multiple users, ensuring only one session has access.
Restricts access to programming software connections requiring a correct password.
Workflows for uploading, debugging, and downloading from password-protected controllers.
Steps to upload a project from a password-protected controller.
Steps to connect to and debug a locked controller by providing the password.
Steps to download a project to a password-protected controller.
Workflow to back up a locked controller's application to a memory plug-in device.
Steps to recover access if the controller password is lost.
Description of microSD card support on Micro830, Micro850, and Micro870 controllers.
Details project backup and restore using microSD cards.
Feature for capturing global and local variables with timestamps to microSD cards.
Feature for storing and loading lists of data to/from recipe files using RCP instruction.
Shows how to flash update Micro800 controller firmware using Connected Components Workbench or microSD card.
Steps to set, change, and clear controller passwords via Connected Components Workbench software.
Guides on making small logic changes in a running project without disconnecting.
Lists possible error codes, fault types, and recommended actions for recovery.
Provides steps to resolve recoverable and non-recoverable faults.
Steps to perform autotuning for PID controllers.
