Rockwell Automation Publication 2080-QR003B-EN-P - October 2023 3
Micro800 Controllers Starter Pack Quick Reference
Wiring the Input Simulator
Micro810 Starter Pack
To start using the Micro810® input simulator, insert the input simulator into the
input terminal of the Micro810 controller as shown.
The input simulator consists of six digital switches and one analog simulator.
Supply 24V DC power to the input simulator. Additional 24V DC connection is
not required to power the Mico810 controller.
Micro820 Starter Pack
To start using the Micro820® input simulator, insert the input simulator into
the input terminal of the Micro820 controller as shown. Verify that the COM0
terminal of the input simulator is connected to the COM0 input terminal of the
Micro820 controller.
The input simulator consists of seven digital switches and one analog
simulator. To use the analog simulator, connect the analog output of the input
simulator to either of the input channel (Inputs I-00, I-01, I-02, and I-03 are
shared between digital and analog inputs) of the Micro820 controller.
Supply 24V DC power to the input simulator. Additional 24V DC connection is
required to power the Micro820 controller.
Micro850 Starter Pack
To start using the Micro850® input simulator, insert the input simulator into
the input terminal of the Micro850 controller as shown.
The input simulator consists of seven digital switches and one analog
simulator. To use the analog simulator, connect the analog output of the input
simulator to the analog input channel of the 2080-IF2 plug-in.
Supply 24V DC power to the input simulator. Additional 24V DC connection is
required to power the Micro850 controller.
To Next Page
Loading...
