228 Rockwell Automation Publication 2080-UM002L-EN-E - November 2021
Appendix C Quickstarts
In the following instructions, the Connected Components Workbench
software is connected to the Micro800 controller.
1. On the Connected Components Workbench software, open the project
for the target controller.
2. Click Connect to connect to the target controller.
On the Device Details toolbar, the Secure tooltip message “Set, Change,
or Clear Micro800 Controller Password Protection” is displayed.
3. Click Secure. Select Set Password.
4. The Set Controller Password dialog appears. Provide password. Confirm
the password by providing it again in the Confirm field.
5. Click OK.
Once a password is created, any new sessions that try to connect to the
controller will have to supply the password to gain exclusive access to the
target controller.
Passwords must have at least eight characters to be valid.
To Next Page
Loading...
Need help?
General
