Rockwell Automation Publication 6200-IN001A-EN-P - October 2019 7
VersaView 5000 Thin Clients, Industrial Computers, and Accessories for Hazardous Locations
Protective I/O Port Dust Caps (Cat. No. 6200V-PLUGS)
Protective I/O port dust caps are for hazardous locations where airborne chemicals or other
particulates can damage exposed I/O ports and later affect their reliability. An ordered kit
supplies dust caps for each I/O port as detailed in Figure 3 on page 12.
The four VersaView 5000 models with conformal coating (Cat. Nos. 6200P-NS3A1K,
6200P-NS3B1K, 6200P-NS3C1K, and 6200T-NAK) are shipped with these protective I/O
dust caps installed.
Operating Systems
For a list of available Microsoft-licensed 64-bit operating systems, see the table in Ve r s aV i e w
5000 Thin Client and Industrial Computer Options on page 6.
No operating system updates have been applied to the factory image beyond any listed service
packs.
To obtain a copy of a factory system image, access the Rockwell Automation® Product
Compatibility and Download Center (PCDC) at
https://compatibility.rockwellautomation.com/Pages/home.aspx
.
ARC FLASH HAZARD: Do not connect or disconnect any accessories to VersaView 5000 devices for
hazardous locations unless power has been switched off and the area is known to be
non-hazardous.
Before power is switched on, verify that any adapter, cable, or power connection accessory is fully
inserted in its port. For adapter and cable accessories, verify that latches are engaged, and any
screws are fully engaged and tightened.
Failure to do so could result in an electric arc that can cause an explosion in a hazardous location.
To Next Page
Loading...
Need help?
General
