Maintenance
Repair
MagneMover LITE Service Manual 117
Rockwell Automation Publication MMI-UM037A-EN-P - April 2020
12. Place the mounting holes on the vehicle over the array posts. Realign the shims if nec-
essary to make sure that they align with the vehicle.
13. Secure the array to the vehicle with the four M4 x 12 mm screws that were removed in
Step 4 and Loctite 243. Tighten each screw to 1.5 N•m [13 in•lb].
NOTE: The Loctite must cure for 2 hours at 22° C [72° F] before using the puck.
14. Replace the vehicle, see Replace Precision Rail Vehicles on page 104.
15. Restart the path.
16. Dispose of the removed magnet array appropriately.
To Next Page
Loading...
