Rockwell Automation MagneMotion MagneMover LITE - Page 73

Maintenance
Repair
MagneMover LITE Service Manual 73
Rockwell Automation Publication MMI-UM037A-EN-P - April 2020
Replace Ethernet Motors
The MagneMover LITE motors can typically be replaced easily depending upon the location
and mounting method for the motor.
Required Tools and Equipment
• Torque wrench with the following bits:
• T30 Torx.
• 10 mm Hex socket.
• 13 mm Hex socket.
• Computer with an Ethernet port and a web browser.
• System MICS file.
Remove the Existing Motor
1. Complete all material transfers (move all material to the appropriate locations) on the
section of the MM LITE transport system where the motor is being replaced.
2. Command all vehicles to positions off the path where the motor is located.
3. Issue a Suspend Movement command for the path where the motor is located.
All vehicles come to a controlled stop.
4. Once all motion has stopped, issue a Reset command for the path where the motor is
located.
The HLC clears all vehicle records.
5. Turn off all electrical and pneumatic power to the section of the MM LITE transport
system where the motor is located.
6. Label the cables connected to the motor.
7. Disconnect all connections.
8. Remove the bolts that secure the motor.