MC16 Operating Manual 09.01.2020
Parameter Object – specifies target object for the function of action. The parameter is not configured in this
field when Local Command is applied.
Option Register Action Event – when the option is enabled then every action starting will additionally
generate associated event in the system.
Area Authentication and Authorisation Options
Option User authentication required – when the option is enabled then users can start object function or
Local Command without Authorisation(s) assigned. It is enough that such users are equipped with
Authentication Factors which are enrolled in the system.
Option Authorisation for Access Point required – when the option is enabled then only users with proper
Authorisation can start object function or Local Command. The Authorisation must include Access Point
type Positive rule for the Access Point where the function is started.
Option Authorisation for Object required – when the option is enabled then only users with proper
Authorisation can start object function or Local Command. The Authorisation must include Object type
Positive rule for the object of the function.
Option Authorisation for Function Parameter required – when the option is enabled then users with
proper Authorisation can start object function or Local Command. The Authorisation must include Parameter
type Positive rule for the parameter of the function.
Area Interactive Options
Interactive options enable to start actions which are not defined within Login Options of an Access Point.
Action can be started on any object depending on user Authorisations. Interactive actions can be started
only on terminals with keypad. Such terminals must have the option [*] key press allowed before PIN
enabled during their low level configuration (RogerVDM).
Option Enable Function Selection – when the option is enabled then user can enter keypad commands to
start functions on the level of Alarm Zones [102]-[104], [106]-[109], Access Doors [121]-[127], [136], Access
Points [151]-[152], [159], [171]-[176], T&A Modes [175] and Authorisation Modes [178]-[186].
Option Enable Object Selection – when the option is enabled then user must enter object Keypad Shortcut
to select the object.
Option Enable Interactive Function – when the option is enabled then user must enter function parameter.
Tab Access Doors
The tab is available when an Access Point is created and it enables to assign Access Door to the point.
Tab Access Terminals
The tab is available when an Access Point is created and it enables to assign Access Terminal(s) to the
point.
Tab Inputs
The tab is available when an Access Point is created and it enables to assign Input(s) to the point. Input
parameters and functions are listed within the description of Input objects.
Tab Outputs
The tab is available when an Access Point is created and it enables to assign Output(s) to the point. Output
parameters and functions are listed within the description of Output objects.
Tab Function Keys
The tab is available when an Access Point is created and it enables to assign Function Key(s) to the point.
Function key parameters and functions are listed within the description of Function Key objects.
Tab Local Commands
The tab is available when an Access Point is created and it enables to assign Local Command(s) to the
point. Local Command parameters and functions are listed within the description of Local Command
objects.
Access Doors
Access Door represents physical door or gate with such devices as door lock, exit button, door contact, etc.
Access Doors are logically linked with Access Points.
To Next Page
Loading...
