Roger MC16 - Page 25

MC16 Operating Manual 09.01.2020
25/52
(MC16-EVC) and wired lockers (MC16-LCK).
176
Grant Door Access with Extended
Lock Pulse
Event
Access Point
When triggered then Access Door of the Access Point is opened for the time
specified by the parameter Lock Pulse Extended. The function is usually used
within Login Options of the Access Point but it can also be assigned to input.
In the second case it is necessary to define Authentication Point and enable
at least single option in the area Authentication and Authorisation Options.
Contrary to function [152] when this function is used then single event is
generated for all associated objects.
177
Set Authorisation Mode
Event
Access Point
When triggered then Authorisation Mode is selected at Access Point.
Function parameter defines which mode is applied when input is triggered.
178
Set Default Authorisation Mode
Event
Access Point
When triggered then Default Authorisation mode is selected at Access Point.
179
Set Negative Authorisation Mode
Event
Access Point
When triggered then Negative Authorisation mode is selected at Access
Point.
180
Set Positive Authorisation Mode
Event
Access Point
When triggered then Positive Authorisation mode is selected at Access Point.
181
Set Normal Authorisation Mode
Event
Access Point
When triggered then Normal Authorisation mode is selected at Access Point.
182
Set External Authorisation Mode
Event
Access Point
When triggered then External Authorisation mode is selected at Access Point.
183
Set Delayed Authorisation Mode
Event
Access Point
When triggered then Delayed Authorisation mode is selected at Access Point.
184
Set Disabled Authorisation Mode
Event
Access Point
When triggered then Disabled Authorisation mode is selected at Access
Point.
185
Authorise Access for External
Authorisation Mode
Event
Access Point
When triggered then access is granted for External Authorisation mode
186
Reject Access for Delayed
Authorisation Mode
Event
Access Point
When triggered then access is denied for Delayed Authorisation mode.
187
Set Do Not Disturb Flag ON
Event
Access Point
When triggered then Do Not Disturb flag and outputs with functions [224],
[226] and [227] are switched on. The function is available only for MC16-HRC
controllers.
188
Set Do Not Disturb Flag OFF
Event
Access Point
When triggered then Do Not Disturb flag and output with function [227] are
switched off while outputs with functions [225] and [226] are switched on. The
function is available only for MC16-HRC controllers.
189
Set Alternately Do Not Disturb
Flag ON/OFF
Event
Access Point
When triggered then Do Not Disturb flag is switched to opposite state.
Outputs with functions [224], [225], [226] and [227] are switched accordingly.
The function is available only for MC16-HRC controllers.