Roger MC16 - Page 26

MC16 Operating Manual 09.01.2020
26/52
190
Set Call Assistance Flag ON
Event
Access Point
When triggered then Call Assistance flag and outputs with functions [228],
[230] and [231] are switched on. The function is available only for MC16-HRC
controllers.
191
Set Call Assistance Flag OFF
Event
Access Point
When triggered then Call Assistance flag and output with function [231] are
switched off while outputs with functions [229] and [230] are switched on. The
function is available only for MC16-HRC controllers.
192
Set Alternately Call Assistance
Flag ON/OFF
Event
Access Point
When triggered then Call Assistance flag is switched to opposite state.
Outputs with functions [228], [229], [230] and [231] are switched accordingly.
The function is available only for MC16-HRC controllers.
193
Set Make Up Room Flag ON
Event
Access Point
When triggered then Make Up Room flag and outputs with functions [232],
[234] and [235] are switched on. The function is available only for MC16-HRC
controllers.
194
Set Make Up Room Flag OFF
Event
Access Point
When triggered then Make Up Room flag and output with function [235] are
switched off while outputs with functions [233] and [234] are switched on. The
function is available only for MC16-HRC controllers.
195
Set Alternately Make Up Room
Flag ON/OFF
Event
Access Point
When triggered then Make Up Room flag is switched to opposite state.
Outputs with functions [232], [233], [234] and [235] are switched accordingly.
The function is available only for MC16-HRC controllers.
196
Set Service Flag ON
Event
Access Point
When triggered then Service flag and outputs with functions [236], [238] and
[239] are switched on. The function is available only for MC16-HRC
controllers.
197
Set Service Flag OFF
Event
Access Point
When triggered then Service flag and output with function [239] are switched
off while outputs with functions [237] and [238] are switched on. The function
is available only for MC16-HRC controllers.
198
Set Alternately Service Flag
ON/OFF
Event
Access Point
When triggered then Service flag is switched to opposite state. Outputs with
functions [236], [237], [238] and [239] are switched accordingly. The function
is available only for MC16-HRC controllers.
199
Set Two Users Mode Toggle
Toggle
Access Point
As long as triggered then Two Users Mode is enabled at Access Point. In
Two Users Mode the access can be granted only if two Access Credentials
with adequate Authorisations are used at the Access Point.
204
Set Two Users Mode ON
Event
Access Point
When triggered then Two Users Mode is enabled at Access Point.
205
Set Two Users Mode OFF
Event
Access Point
When triggered then Two Users Mode is disabled at Access Point.
206
Set Cafeteria Flag ON
Event
Access Point
When triggered then Cafeteria flag and outputs with functions [212], [214] and
[215] are switched on. The function is available only for MC16-HRC