Rohde & Schwarz 1309.6000.08 - Measuring the Transmission Magnitude; Measuring the Transmission Phase (Models with Integrated VSWR Bridge Only)

Two-port measurements with the tracking generator R&S FSH
1309.6275.12 4.54 E-2
Measuring the transmission magnitude
Connect the DUT between the tracking generator
output and the RF input.
 Press the FORMAT softkey.
 Using the rotary knob or the cursor keys, select
MAGNITUDE from the menu and confirm by
pressing either the FORMAT softkey or the
ENTER key.
The R&S FSH will indicate the transmission magnitude
and the message TRANSMISSION VECTOR (CAL)
MAGNITUDE in the upper right-hand corner of the
display.
Setting of the reference position:
 Press the AMPT key
 Press the REFPOS softkey
 Using the rotary knob or the cursor keys, adjust the
reference position or
 Using the numeric keys enter a new reference
position and confirm with the ENTER key or the
REFPOS softkey.
Measuring the transmission phase (models with integrated VSWR bridge only)
 Press the FORMAT softkey.
 Using the rotary knob or the cursor keys, select
PHASE from the menu and confirm by pressing
either the FORMAT softkey or the ENTER key.