Measuring with Transducer Factors R&S FSH
1309.6275.12 4.84 E-2
Operating sequence:
Press the AMPT key.
Press the TRANSDUCER softkey.
The softkey menu for operation of transducer factors is
displayed on the screen.
N.B : Transducer factors are not available for
measurements with the tracking generator or
the Power Sensors. The TRANSDUCER
softkey is therefore interactive.
Two transducer factors can be selected with the menu
entries SELECT PRIMARY TRANSDUCER and
SELECT SECONDARY TRANSDUCER. [ ] PRIMARY
TRANSDUCER and [ ] SECONDARY TRANSDUCER
are used to switch the selected transducer factors on
and off.
Press the SELECT PRIMARY TRANSDUCER
softkey.
The R&S FSH displays a list of transducer factors
available in the unit. The cursor is on the active
transducer factor (line highlighted). If no transducer is
active, the cursor is on the first item in the list.
Select the desired transducer factor with the rotary
knob or the cursor keys and switch it on with the
SELECT softkey.
Note: With an inserted SD card, switch between
internal memory and memory card by
pressing the INTERNAL/SD-CARD softkey.
Quit the transducer menu with the EXIT softkey.
To Next Page
Loading...
