Using the Markers R&S FSH
1309.6275.12 4.28 E-2
Automatic marker positioning:
Automatic positioning of markers in multimarker mode
is similar to that of the normal marker. The different
functions always apply to the active marker, which is
also indicated for the various functions in the MKR->
menu (example: Selected Marker to Peak).
In addition, it is possible to position all activated
markers (M1 to M6) at the peak of a trace.
In the SET TO PEAK menu, select ALL MARKERS
and confirm this with the ENTER key or the SET
TO PEAK softkey.
The R&S FSH sets all activated markers to the maxima
of the trace.
Displaying all multimarker values:
The R&S FSH can display a list of all activated markers and their values.
Press the VIEW LIST softkey.
The R&S FSH displays a list of all activated markers
and delta markers.
If you press the VIEW LIST softkey again, the
R&S FSH closes the marker table extension from
marker 3 to 6.
Deactivating markers:
Markers can be deactivated one at a time or all at once.
To Next Page
Loading...
