Contents R&S FSH
1309.6275.12 I.4 E-2
Optimizing the reference level ..................................................................................................4.41
Power readout...........................................................................................................................4.41
Setting the trigger......................................................................................................................4.41
Measuring the occupied bandwidth .............................................................................................4.42
Selecting a standard .................................................................................................................4.43
Setting the reference level ........................................................................................................4.43
Setting the channel bandwidth ..................................................................................................4.44
Entering the power percent to determine the occupied bandwidth...........................................4.44
Displaying the occupied bandwidth...........................................................................................4.45
Changing the span....................................................................................................................4.45
Two-port measurements with the tracking generator ................................................................4.45
Measuring the transmission of two-ports ..................................................................................4.48
Vector measurement....................................................................................................4.50
Vector transmission measurement ..............................................................................4.52
Measuring the transmission magnitude .......................................................................4.54
Measuring the transmission phase (models with integrated VSWR bridge only) ........4.54
Supplying DC voltage to active DUTs (models with integrated VSWR bridge only) ....4.55
Scalar measurement of reflection ................................................................................4.55
Vector measurement of reflection................................................................................4.58
Measuring the reflection magnitude.............................................................................4.59
Measuring the reflection phase....................................................................................4.60
Simultaneous measurement of magnitude and phase of the reflection.......................4.60
Displaying the reflection in the Smith chart...................................................4.61
Selecting the calibration standards: .............................................................................4.64
Cable Measurements......................................................................................................................4.66
Cable selection .........................................................................................................................4.67
Selecting the frequency range ..................................................................................................4.68
Calibrating the test setup ..........................................................................................................4.69
Measurements using the power sensor.......................................................................................4.72
Connecting the power sensor ...................................................................................................4.72
Zeroing the power sensor .........................................................................................................4.74
Selecting the unit for the power readout ...................................................................................4.75
Setting the averaging time ........................................................................................................4.75
Taking additional loss or gain into account...............................................................................4.76
Measuring forward and reflected power ......................................................................................4.76
Zeroing the power sensor .........................................................................................................4.79
Setting the power measurement weighting...............................................................................4.80
Selecting the unit for the power readout ...................................................................................4.80
Taking additional attenuation into account................................................................................4.81
To Next Page
Loading...
