Preparing for Use
R&S
®
FPL1000
19Getting Started 1323.1602.02 ─ 07
4.4.1 Placing the R&S FPL1000 on a Bench Top
To place the R&S FPL1000 on a bench top
1. Place the R&S FPL1000 on a stable, flat and level surface. Ensure that the
surface can support the weight of the R&S FPL1000. For information on the
weight, see the data sheet.
2. CAUTION! Foldable feet can collapse. See "Setting up the instrument"
on page 8.
Always fold the feet completely in or out. If they are folded out, do not place
anything on top or underneath.
3. CAUTION! R&S FPL1000 can fall over and cause injury. The top surface is
too small for stacking. Never stack another instrument on top of the
R&S FPL1000.
As an alternative, you can mount several instruments in a rack.
4. NOTICE! Overheating can damage the R&S FPL1000.
Prevent overheating as follows:
● Keep a minimum distance of 10 cm between the fan openings of the
R&S FPL1000 and any object in the vicinity.
● Do not place the R&S FPL1000 next to heat-generating equipment such
as radiators or other instruments.
4.4.2 Mounting the R&S FPL1000 in a Rack
To prepare the rack
1. Observe the requirements and instructions in "Setting up the instrument"
on page 8.
Setting Up the R&S FPL1000
To Next Page
Loading...
