Rohde & Schwarz FPL1000 Series - Connecting to LAN

Preparing for Use
R&S
®
FPL1000
25Getting Started 1323.1602.02 ─ 07
The operating system shuts down. The LED changes to orange.
To disconnect from power
The R&S FPL1000 is in the standby state.
1. NOTICE! Risk of data loss. If you disconnect the R&S FPL1000 from power
when it is in the ready state, you can lose settings and data. Shut it down first.
Set the switch on the power supply to position [0].
See Chapter 5.2.2, "AC Power Supply Connection and Main Power Switch",
on page 43.
The LED of the standby key is switched off.
2. Disconnect the R&S FPL1000 from the power source.
4.7 Connecting to LAN
You can connect the instrument to a LAN for remote operation via a PC. For
details on the connector, see Chapter 5.2.7, "LAN", on page 44.
► NOTICE! Risk of network failure.
Consult your network administrator before performing the following tasks:
● Connecting the instrument to the network
● Configuring the network
● Changing IP addresses
● Exchanging hardware
Errors can affect the entire network.
Connect the R&S FPL1000 to the LAN via the LAN interface on the rear panel
of the instrument.
Windows automatically detects the network connection and activates the
required drivers.
By default, the R&S FPL1000 is configured to use DHCP and no static IP
address is configured.
The default instrument name is <Type><variant>-<serial_number>, for
example, FPL1003-123456. For information on determining the serial
number, see Chapter 5.2.14, "Device ID", on page 47.
Connecting to LAN