Preparing for Use
R&S
®
FPL1000
27Getting Started 1323.1602.02 ─ 07
4.9 Connecting an External Monitor
You can connect an external monitor (or projector) to the "DVI" connector on the
rear panel of the R&S FPL1000 (see also Chapter 5.2.6, "DVI", on page 44).
Screen resolution and format
The touchscreen of the R&S FPL1000 is calibrated for a 16:10 format. If
you connect a monitor or projector using a different format (e.g. 4:3), the
calibration is not correct and the screen does not react to your touch actions
properly.
The touchscreen has a screen resolution of 1280x800 pixels. Most external
monitors have a higher screen resolution. If the screen resolution of the
monitor is set higher than the instrument's resolution, the application win-
dow uses an area of 1280x800 pixels on the monitor display. For full screen
display, adjust the monitor's screen resolution.
The R&S FPL1000 supports a minimum resolution of 1280x768 pixels.
1. Connect the external monitor to the R&S FPL1000.
2. Press the [Setup] key.
3. Press the "Display" softkey.
4. Select the "Configure Monitor" tab in the "Display" dialog box.
The standard Windows "Screen Resolution" dialog box is displayed.
Connecting an External Monitor
To Next Page
Loading...
