Rohde & Schwarz RTA4004 - Page 687

Remote control commands
R&S
®
RTA4000
687User Manual 1335.7898.02 ─ 08
Parameters:
<StatusBit> 0 | 1 | X
*RST: X
TRIGger:A:MILStd:STATus:DBCaccept <StatusBit>
Triggers on the state of the dynamic bus control accept bit of the status word.
Parameters:
<StatusBit> 0 | 1 | X
*RST: X
TRIGger:A:MILStd:STATus:INSTrument <StatusBit>
Triggers on the state of the instrumentation bit of the status word.
Parameters:
<StatusBit> 0 | 1 | X
*RST: X
TRIGger:A:MILStd:STATus:MERRor <StatusBit>
Triggers on the state of the message error bit of the status word.
Parameters:
<StatusBit> 0 | 1 | X
*RST: X
TRIGger:A:MILStd:STATus:SREQuest <StatusBit>
Triggers on the state of the service request bit of the status word.
Parameters:
<StatusBit> 0 | 1 | X
*RST: X
TRIGger:A:MILStd:STATus:SUBSystem <StatusBit>
Triggers on the state of the subsystem flag bit of the status word.
Parameters:
<StatusBit> 0 | 1 | X
*RST: X
TRIGger:A:MILStd:STATus:TERMinal <StatusBit>
Triggers on the state of the terminal flag bit of the status word.
Serial bus analysis