Rohde & Schwarz RTE1104 - Results

Remote control commands
R&S
®
RTE
1349User Manual 1326.1032.02 ─ 20
18.14.6 Results
MTESt:RESult:STATe?................................................................................................. 1349
MTESt:RESult[:RESult]?...............................................................................................1349
MTESt:RESult:COUNt:WAVeforms?...............................................................................1349
MTESt:RESult:COUNt:REMaining?............................................................................... 1350
MTESt:RESult:COUNt:FWAVeforms?.............................................................................1350
MTESt:RESult:COUNt:FAILures?.................................................................................. 1350
MTESt:RESult:FRATe?.................................................................................................1351
MTESt:RESult:STATe? <MaskTestName>
Shows if the test is running or has finished. The state is set to "Finished" if no acquisi-
tions remain (see MTESt:RESult:COUNt:REMaining? on page 1350).
Query parameters:
<MaskTestName>
Return values:
<State> RUNNing | FINished
*RST: RUNNing
Usage: Query only
Asynchronous command
MTESt:RESult[:RESult]? <MaskTestName>
Returns the test result.
A test has failed if the number of sample hits or acquisition hits exceeds the limit of
"Violation tolerance" hits (see MTESt:TOLerance on page 1334, MTESt:RESult:
COUNt:FAILures? on page 1350 and MTESt:RESult:COUNt:FWAVeforms?
on page 1350).
Query parameters:
<MaskTestName>
Return values:
<TestResult> PASS | FAIL
*RST: PASS
Usage: Query only
Asynchronous command
MTESt:RESult:COUNt:WAVeforms? <MaskTestName>
Returns the number of tested acquisitions.
Query parameters:
<MaskTestName>
Mask testing