Rohde & Schwarz RTE1104 - Ethernet Search Setup; Search on Decoded Ethernet Data

Protocol analysis
R&S
®
RTE
707User Manual 1326.1032.02 ─ 20
●
Chapter 7.1.3, "Zooming for details", on page 284
Export of decode results
1. In the protocol decode table, press "Export".
The "Numeric Results" dialog opens.
For details, see Chapter 12.2.4, "Numeric Results", on page 492.
2. Select the decode results you want to export, the file format, and the delimiter.
3. Tap "Save" or "Save as".
Remote commands
Remote commands are described in Chapter 18.17.12.3, "Decode results",
on page 1656.
13.11.6 Search on decoded Ethernet data
Using the search functionality, you can find various events in the decoded data. You
can find the same events that you can trigger on, and even many more, since several
event types can also be combined.
Before you can start the search, you have to configure the bus correctly and acquire
decoded data.
To search on decoded data, set the search source to "SerBus" for the configured proto-
col.
For general information on how to handle the search functionality, see Chapter 11,
"Search functions", on page 445.
If you need information on how to get started with searching Ethernet data, see Chap-
ter 13.11.6.3, "Searching Ethernet data", on page 710. Otherwise proceed with the
Ethernet search setup.
13.11.6.1 Ethernet search setup
Access: [SEARCH] > "Setup" tab
Ethernet 10BASE-T and 100BASE-TX (option R&S RTE-K8)