Measurements
R&S
®
RTE
336User Manual 1326.1032.02 ─ 20
6. Optionally, define a gate to restrict the measurement to a part of the waveform. See
Chapter 8.2.3.1, "Using measurement gates", on page 341.
If you enabled the measurement with the toolbar icon and drew a rectangle on the
diagram, the gate is already defined and enabled.
7. To compile and display statistics for the measurement, enable "Statistics". See also
Chapter 8.2.10.1, "Statistics", on page 382.
8. Enable each measurement using "State".
8.2.1.3 General measurement settings
Automatic measurements are configured in the "Measurements" dialog box.
Access: "Meas" menu > "Overview"
This section describes the settings that relate to all measurements. Specific settings
are described in the corresponding category chapters:
●
Chapter 8.2.5.2, "Settings for amplitude/time measurements", on page 355
●
Chapter 8.2.6.2, "Settings for eye diagram measurements", on page 363
●
Chapter 8.2.7.2, "Settings for spectrum measurements", on page 365
●
Chapter 8.2.8.5, "Settings for histogram measurement", on page 375
State
Starts the selected measurement.
Automatic measurements
To Next Page
Loading...
