Rohde & Schwarz RTE1104 - Page 1805

Remote control commands
R&S
®
RTE
1805User Manual 1326.1032.02 ─ 20
TRIGger<m>:USB:WETCheck <WithETCheck>
Defines, whether the Endpoint Type (ET) check shall be activated or not.
Parameters:
<WithETCheck> ON | OFF
*RST: OFF
TRIGger<m>:USB:WFRN <FrameNoChk>
Defines, whether the frame number check shall be activated or not.
Parameters:
<FrameNoChk> ON | OFF
*RST: OFF
TRIGger<m>:USB:WPAY <PayloadCheck>
Defines, whether the payload data check shall be activated or not.
Parameters:
<PayloadCheck> ON | OFF
*RST: OFF
TRIGger<m>:USB:WPID <WithPIDCheck>
Defines, whether the packet ID error check shall be activated or not.
Parameters:
<WithPIDCheck> ON | OFF
*RST: OFF
TRIGger<m>:USB:WPOR <WithPortCheck>
Defines, whether the port check shall be activated or not.
Parameters:
<WithPortCheck> ON | OFF
*RST: OFF
TRIGger<m>:USB:WSEU <WithSEUCheck>
Defines, whether the SEU check shall be activated or not.
For SEU, see "SEU" on page 834.
Parameters:
<WithSEUCheck> ON | OFF
*RST: OFF
Protocols