Protocol analysis
R&S
®
RTE
742User Manual 1326.1032.02 ─ 20
Data min ← Transmission Sequence setup
Sets the data pattern. Enter the bytes in msb first bit order. The maximum pattern
length is 64 bit. Waveform data is compared with the pattern byte-by-byte.
Remote command:
TRIGger<m>:SENT:TDMN on page 1708
Data max ← Transmission Sequence setup
The second data pattern is required to specify a range with conditions "In range" and
"Out of range".
Remote command:
TRIGger<m>:SENT:TDMX on page 1708
Serial Message setup
Configures the trigger conditions for a serial message.
Note: The displayed parameters depend on the selected "Sequence". The instrument
indicates the data setting parameters when you select "ID+Data", see "Type"
on page 738.
Trigger setting parameters of the serial message types
Short Serial Message Enhanced Serial Message
Sequence ← Serial Message setup
Selects the condition for triggering in a serial message.
You can trigger on the end of an identifier nibble or the combination of the identifier and
data nibble(s).
Remote command:
TRIGger<m>:SENT:STYPe on page 1708
ID Type ← Serial Message setup
Selects the message ID format for the enhanced serial message type.
You can select either 4-bit or 8-bit message ID.
Remote command:
TRIGger<m>:SENT:SIDType on page 1709
Identifier Condition ← Serial Message setup
The available operators:
●
Equal, Not equal
●
Less than, Greater than
SENT (option R&S
RTE-K10)
To Next Page
Loading...
