Rohde & Schwarz RTE1104 - Page 749

Protocol analysis
R&S
®
RTE
749User Manual 1326.1032.02 ─ 20
<sb:DESCRIPTION></sb:DESCRIPTION>
<sb:ID-VALUE>04</sb:ID-VALUE>
<sb:ID-LENGTH>8</sb:ID-LENGTH>
<sb:DATA-SIZE>12</sb:DATA-SIZE>
</sb:FRAME>
<sb:FRAME NAME="Manufacturer Code" STATE="OFF">
<sb:DESCRIPTION></sb:DESCRIPTION>
<sb:ID-VALUE>05</sb:ID-VALUE>
<sb:ID-LENGTH>8</sb:ID-LENGTH>
<sb:DATA-SIZE>12</sb:DATA-SIZE>
</sb:FRAME>
<sb:FRAME NAME="Sensor Type" STATE="ON">
<sb:DESCRIPTION>specifies the SENT Sensor Type</sb:DESCRIPTION>
<sb:ID-VALUE>03</sb:ID-VALUE>
<sb:ID-LENGTH>8</sb:ID-LENGTH>
<sb:DATA-SIZE>12</sb:DATA-SIZE>
<sb:SIGNALS>
<sb:SIGNAL ID="Sensor Class">
<sb:SHORT-NAME>Sensor Class</sb:SHORT-NAME>
<sb:BIT-POSITION>11</sb:BIT-POSITION>
<sb:BIT-LENGTH>12</sb:BIT-LENGTH>
<sb:BYTE-ORDER>MSB</sb:BYTE-ORDER>
<sb:VALUE-TYPE>ENUM</sb:VALUE-TYPE>
<sb:FACTOR>1.0</sb:FACTOR>
<sb:OFFSET>0.0</sb:OFFSET>
<sb:MIN>0</sb:MIN>
<sb:MAX>32.0</sb:MAX>
<sb:ENUM-VALUES>
<sb:ENUM INDEX="0" LABEL="Not Specified"/>
<sb:ENUM INDEX="1" LABEL="P"/>
<sb:ENUM INDEX="2" LABEL="P/-"/>
<sb:ENUM INDEX="3" LABEL="P/S"/>
<sb:ENUM INDEX="4" LABEL="P/S/Default T"/>
<sb:ENUM INDEX="5" LABEL="P/S/Sensor-Specific T"/>
<sb:ENUM INDEX="6" LABEL="P1/P2"/>
<sb:ENUM INDEX="7" LABEL="P/Default T"/>
<sb:ENUM INDEX="8" LABEL="P/Sensor-Specific T"/>
<sb:ENUM INDEX="9" LABEL="P1/P2/Default T"/>
<sb:ENUM INDEX="10" LABEL="P1/P2/Sensor-Specific T"/>
<sb:ENUM INDEX="16" LABEL="Not Defined"/>
<sb:ENUM INDEX="17" LABEL="MAF (hi-res,lin)"/>
<sb:ENUM INDEX="18" LABEL="MAF (hi-res,non-lin)"/>
<sb:ENUM INDEX="19" LABEL="MAF (hi-res,lin) / Pressure"/>
<sb:ENUM INDEX="20" LABEL="MAF (hi-res,non-lin) / Pressure"/>
<sb:ENUM INDEX="21" LABEL="MAF (lin) / Pressure (hi-res)"/>
<sb:ENUM INDEX="22" LABEL="MAF (non-lin) / Pressure (hi-res)"/>
</sb:ENUM-VALUES>
</sb:SIGNAL>
</sb:SIGNALS>
</sb:FRAME>
SENT (option R&S
RTE-K10)