Rohde & Schwarz Scope Rider RTH - Page 323

Remote Control Commands
R&S
®
Scope Rider RTH
323User Manual 1326.1578.02 ─ 12
Parameters:
<Level> Range: -10 to 10
Increment: 1E-3
*RST: 0
Default unit: V
TRIGger:RUNT:POLarity <Polarity>
Sets the pulse polarity, that is the direction of the first pulse slope. You can trigger on:
●
Positive going pulses. The width is defined from the rising to the falling edge.
●
Negative going pulses. The width is defined from the falling to the rising edge.
●
Both positive and negative going pulses
Parameters:
<Polarity> POSitive | NEGative | EITHer
*RST: POSitive
TRIGger:RUNT:RANGe <Condition>
Defines an additional time limit of the runt pulse.
Parameters:
<Condition> ANY | LONGer | SHORter | EQUal | NEQual | WITHin | OUTSide
ANY
Triggers on all runts fulfilling the level condition, without time lim-
itation.
LONGer | SHORter
Defines a minimum time during which the signals match the pat-
tern definition. The minimum time is defined by
EQUal | NEQual
Triggers on pulses equal or not equal a given runt width that is
set using TRIGger:RUNT:WIDTh. In addition, a tolerance can
be set around the specified width using TRIGger:RUNT:DELTa
.
WITHin | OUTSide
Triggers on pulses inside or outside a given range. The range is
set using ... and ....
*RST:
LONGer
TRIGger:RUNT:WIDTh <Duration>
Sets the width for comparison ranges EQUal, UNEQual, SHORter, and LONGer.
See TRIGger:WIDTh:RANGe.
Waveform Setup