Rohde & Schwarz Scope Rider RTH - Page 331

Remote Control Commands
R&S
®
Scope Rider RTH
331User Manual 1326.1578.02 ─ 12
EQUal | NEQual
Triggers on intervals equal or not equal a given interval width
that is set using TRIGger:INTerval:WIDTh. In addition, a tol-
erance can be set around the specified width using TRIGger:
INTerval:DELTa.
WITHin | OUTSide
Triggers on intervals inside or outside a given range. The range
is set using ... and ....
*RST: LONGer
TRIGger:INTerval:WIDTh <Duration>
Sets the time between two pulses for comparisons EQUal, UNEQual, SHORter, and
LONGer.
Parameters:
<Duration> Range: 800E-12 to 10000
Increment: 100E-9
*RST: 5E-9
Default unit: s
TRIGger:INTerval:DELTa <Tolerance>
Sets a range Δt to the specified width, which is defined using TRIGger:INTerval:
WIDTh. The command is relevant for comparisons EQUal and UNEQual.
Parameters:
<Tolerance> Range: 0 to 5000
Increment: 500E-12
*RST: 0
Default unit: s
TRIGger:INTerval:MINWidth <MinDuration>
Sets the lower time limit of the interval for comparisons WITHin and OUTSide.
Parameters:
<MinDuration> Range: 800E-12 to 10000
Increment: 100E-9
*RST: 5E-9
Default unit: s
TRIGger:INTerval:MAXWidth <MaxDuration>
Sets the upper time limit of the interval for comparisons WITHin and OUTSide.
Waveform Setup