ROJ SUPER ELF S3 - Sensors Sensitivity Settings

SUPER ELF S3 – Dornier
14
Filling Draw back
This parameter allows to enable or disable the yarn filling draw back after yarn cut. It is also
possible to choose how large angle to use to pull the yarn back.
• Possible setting:
off disabled filling draw back
1 minimum angle for draw back
2 middle angle for draw back
3 maximum angle for draw back
• Recommended setting: Use mostly "2" and "3" values .
Sensors sensitivity settings
Reaction time of the Feed Sensor
Set the sensitivity for the photocell with function as input yarn break sensor
• Possible setting: 2, 3, 4, 5 and OFF (OFF = Feed Sensor OFF)
• Recommended setting: 3
Note: increase the value in case of “false” yarn break stops