56
Jun. 2005
Restoring the Rhythm Stored in
the User Memory to Their
Original Factory Settings
Use the following procedure to restore only the rhythm stored in the User
Memory to their factory settings.
1. Touch <Rhythm> on the Main screen.
2. Touch < > (Utility) on the Rhythm screen.
fig.02-10_55
3. Touch <Reset User> on the Sub-window.
The confirmation message appears on the screen.
4. Touch <OK>.
The Rhythm that had been stored in the User Memory button will return
to the factory settings.
Restoring All Settings Other Than
the User Memory to the Original
Factory Settings
You can restore all of the settings other than the User memory to their original
factory settings.
This function is called “Panel Reset.”
1. Make sure there is no floppy disk in the disk drive before carrying out the
procedure.
2. Touch <System> on the Main screen.
3. The System screen appears.
fig.00-37.eps
4. In the System screen, touch <Utility> to open the Utility screen.
fig.00-38.eps
You can also use the following method to return to the factory-set
condition.
1. Make sure there is no floppy disk in the disk drive before carrying
out the procedure.
2. Turn down the volume to the minimum level, then turn off the
power.
3. While holding down the [One Touch Program] button, press the
[Power On] switch to turn the power on.
fig.00-41
The following screen appears.
fig.00-40.eps
Never switch off the power while this operation is in progress!
Power On
Program
One Touch
Set
What is the User Memory?
The User memory is the area within the instrument where User rhythms
you create as well as rhythms from Music Style Disks are stored.
You can also copy rhythms saved on floppy disks to the User memory.
To Next Page
Loading...
