55
AT-80SL
8. To store the Rhythm in User memory, touch <OK>.
The saving of the rhythm to User memory begins.
Once the Rhythm has been accommodated in memory, the Rhythm
screen will reappear.
FACTORY RESET
INSTRUCTIONS
Restoring All the Factory Default
Settings
You can restore all of the settings stored in the AT-80SL to what they were
when the instrument shipped from the factory. This function is called “Factory
Reset.”
1. Make sure there is no floppy disk in the disk drive before carrying out the
procedure.
2. Touch <System> on the Main screen.
The System screen appears.
fig.00-37.eps
3. In the System screen, touch <Utility> to open the Utility screen.
fig.00-38.eps
4. In the Utility screen, touch <Factory Reset>.
fig.00-39.eps
To restore all settings other than the User memory to their original factory
settings, touch <Panel Reset>.
The confirmation message appears on screen.
fig.00-40.eps
If you touch <Cancel>, the Factory Reset will not be performed, and you
will return to the System screen.
5. When you touch <OK>, the Factory Reset operation will begin, and the
settings will return to the factory-set condition.
Never switch off the power while this operation is in progress!
fig.00-40.eps
Loading factory default settings will erase any Registrations currently in the
memory of the AT-80SL. To save the registrations you are currently using.
To reset only the User memory to its original factory settings.
To Next Page
Loading...
