Roland CAMM-1 PRO CM-300 User Manual

26
4 Adjustment
4
4-2 SERVICE MODE
[ ],[ ],[ ] + [SETUP] key
Sensor
DRAM
EEROM
Ageing
Force
Key
Calib.
Landing
Checks whether DRAM is functioning properly.
Checks whether sensor is functioning properly.
SENSOR ON=1/OFF=0, F=FRONT, R=REAR, P=PINCHROLL
Checks whether EEROM is functioning properly.
This is for MOTOR BALANCE ADJUSTMENT.
This is for PEN PRESSURE ADJUSTMENT. (page)
Push panel key in sequence of [MENU],[ENTER],
[ ],[ ],[ ],[ ],[SETUP],[TEST]key to check.
This is for calibration.
This is checking softlanding function.
[ ],[ ] key to select.
[ENTER] key to carry out.
[MENU] key
[MENU] key
[MENU] key
[MENU] key
[MENU] key
[MENU] key
[MENU] key
[MENU] key
vice mode
MA120 B110
Displays FLASHROM version.
Service mode
ROM MA120 B110
M = main, B = Boot
Grit calibration
0.00% - 0.10%
Car. calibration
0.00% - 0.10%
Slider AD:128
[ * ]
[ 400, 400]
Stop - ENTER
[ 1, 1]
Start - ENTER
Force adjust
[ UP] 20g
Force adjust
[DOWN] 20g
Cutter
Pen
Grit
Carriage
[ENTER] key
Select tool
Cutter Pen
F=0 R=0 P=0
Carr.=0 Cover=0
[MENU] key
[MENU] key
Cut ATK BRK
1 -1
Pen ATK BRK
0 1
[ENTER] key
[MENU] key
[SETUP] key
[MENU] key
[MENU] key
Land test
plotting..
Land test
plotting..
[TEST] key
[TEST] key
DRAM check [2M]
*******
EEROM check
*******
Ageing ready?
Start - ENTER
Key test
**********
Select axis
Grit Carriage
[ENTER] key
Test draw mode
Move TOOL CARRIAGE fulley to right end.
Turn on the POWER. and press
[SETUP] key within 1 second.

Roland CAMM-1 PRO CM-300 Specifications

General

Repeatability	±0.1 mm
Cutting Width	300 mm
Interface	RS-232C
Power Supply	AC 100-240V, 50/60Hz
Maximum Cutting Area	300 mm x 2000 mm
Acceptable Material Width	50-300 mm
Maximum Cutting Speed	100 mm/sec
Resolution	0.025 mm
Media Width	50-300 mm
Weight	6.5 kg