94
Erasing Tracks from a CD-RW Disc
(continued)
You can remove finalization from a CD-RW disc (Page 99) so that the disc can once again
be used for recording. Removing finalization will not erase the recorded tracks.
* In order to perform this operation, you’ll need the included, dedicated AC adaptor.
1
Insert the CD-RW disc that you want to edit, and press the [CD] button.
CD becomes the audio source.
2
Press the [MENU] button to access the menu screen, and choose
“Unfinalize?”
fig.menu-finalize-e.eps
Press the [MENU] button to access the menu screen.
Use the [ ] [ ] buttons to choose “Unfinalize?”
Press the [ENTER] button to confirm your choice.
3
If you’re sure you want to proceed, press the [ENTER] button.
(Note that the process cannot be interrupted once you’ve started it. If you decide that
you don’t want to begin the process, press the [EXIT] button.)
fig.finalize-mssg-e.eps
The display will show “Processing..,” and finalization will be removed from the disc.
During this process, a timer is displayed, counting down the time until the operation is
completed.
When finalization has been removed, you’re returned to the audio source screen.
Removing Finalization
Count-down (min:sec)
You can’t remove finalization from a CD-R disc.
Important
CD-2u_SD-2u_e.book 94 ページ ２０１３年１月２４日 木曜日 午前１１時３４分
To Next Page
Loading...
