Getting Ready
18
If you’re using the FA-08
If you want to place the FA-08 on a stand, please use the KS-12, KS-18Z, or KS-G8B stands manufactured by Roland.
KS-12
Adjust the width of the stand
so that the rubber feet of the
FA t into the rubber feet
receptacles
Top view
KS-18Z
Align the rear of the
FA with the rear of
the stand
Adjust so that the
height does not
exceed 1 meter
(Adjust the stand
to a level no
higher than the
fth level from the
bottom)
Adjust the width of the stand
so that the rubber feet of the FA
straddle the stand
Top view
KS-G8B
Align the front of
the FA with the
rubber base of
the stand
Top view
• Keep the rubber feet of
the FA on the inside of
the stand
• Ensure that the rubber
base of the stand does
not contact the screws
of the FA
To Next Page
Loading...
